Jet JTAS-10XL Operating Instructions And Parts Manual

Contents

Jet JTAS-10XL Operating Instructions And Parts Manual Manual pdf 12 page image

12Blade Alignment• Tool: 8mm Hex Wrench, combination square,markerBlade alignment with the table is adjusted at thefactory. After a period of use, or, after movingthe saw to another location, the blade may nolonger be aligned with the table. To check andalign the blade: see Figure 131. Disconnect the saw from the powersource.1. Raise the blade guard up and out of the wayof the blade.2. Unlock fence and move away from theblade so as to expose the right T-slot.3. Choose a tooth on the far side of the bladeand directly over the insert. Mark the toothwith a marker. Measure the distance fromthe side of the blade to the right T-slot edgeusing a combination square. Make sure tomeasure between the teeth not on the tooth,Figure 13.4. Rotate the blade toward the front so that themarked tooth is just above the insert.Measure the distance from the side of theblade to the right T-slot edge. The twomeasurements should be the same.5. If they are not the same, loosen four hexsocket cap screws (A, Fig. 14) that hold thetable to the base. Two are shown in Figure14.6. Make the needed adjustments and tightenthe four hex socket cap screws firmly.7. Check the alignment once again aftertightening hardware.