Jet JTSS-1600 Operating Instructions Manual

Also see for JTSS-1600: Operating instructions

Contents

Crosscut table and telescopic arm are aligned ex works (Thetable surface must be in level with the sliding table).The crosscut table can be positioned along the sliding table.Start the machine with care.7.8 Crosscut fence setupCrosscut fence setup shall never be performed when themachine is running.The cross-cut table has 2 precision holes, allowing thecrosscut fence to be put in 2 positions:At the back and front of the cross-cut table.Simply put the fence onto the crosscut table and lock it inposition using the two knobs. Fig 31.Fig 31The 90° adjustable stops are factory set.Calibration of the scale on the crosscut fence:The scale on the fence is factory set and needs no furtheradjustments.To check the settings, put the stop at a certain measure andcut off a sample.Measure the exact length of the sample, unlock the screwwhich holds the fence pivoting T-nut and move the fenceuntil the measurement corresponds to the length of thepreviously cut length.When using the telescopic extension, the material stop hasto be set to the very end to make the different scalescorrespond with one another.The best way to check that all scales correspond, is to makeseveral test cuts on the different scales.7.9 Mitre fence setupMitre fence setup shall never be performed when themachine is running.For good workpiece support, the fence profile must be setclose to the saw blade (Fig 32)Fig 327.10 Rip fence setupRip fence setup shall never be performed when the machineis running.To move the fence, lift the handle (1, Fig 33) halve way.Fig 33When cutting small workpieces or with the sawunit inclinedat 45°, the fence profile must be used in the low position.(Fig 34).Fig 34

/ 17

Related manuals for Jet JTSS-1600