Jet JWBS-9X Operating Instructions Manual

Also see for JWBS-9X: Operating instructions

Contents

Jet JWBS-9X Operating Instructions Manual Manual pdf 4 page image

43.2 General safety notesWoodworking machines can be dangerous if not used properly.Therefore the appropriate general technical rules as well as thefollowing notes must be observed.Read and understand the entire instruction manual beforeattempting assembly or operation.Keep this operating instruction close by the machine, protectedfrom dirt and humidity, and pass it over to the new owner if youpart with the tool.No changes to the machine may be made.Daily inspect the function and existence of the safety appliancesbefore you start the machine.Do not attempt operation in this case, protect the machine byunplugging the mains cord.Remove all loose clothing and confine long hair.Before operating the machine, remove tie, rings, watches, otherjewellery, and roll up sleeves above the elbows.Wear safety shoes; never wear leisure shoes or sandals.Always wear the approved working outfit- safety goggles- ear protection- dust protectionDo not wear gloves while operating this machine.For the safe handling of saw blades wear work gloves.Observe the chapter “save operation” in this manual.Control the stopping time of the machine, it may not be longerthan 10 seconds.Insure that the workpiece does not roll when cutting roundpieces.Use suitable table extensions and supporting aids for difficult tohandle workpieces.Always lower the blade guide close to the workpiece.With the machine table is inclined use the fence and position iton the bottom side only.Always hold and guide the workpieces safely during machining.Remove cut and jammed workpieces only when motor is turnedoff and the machine is at a complete standstill.Install the machine so that there is sufficient space for safeoperation and workpiece handling.Keep work area well lighted.The machine is designed to operate in closed rooms and mustbe placed stable on firm and levelled ground.Make sure that the power cord does not impede work andcause people to trip.Keep the floor around the machine clean and free of scrapmaterial, oil and grease.Stay alert!Give your work undivided attention. Use common sense.Keep an ergonomic body position.Maintain a balanced stance at all times.Do not operate the machine when you are tired.Do not operate the machine under the influence of drugs,alcohol or any medication. Be aware that medication canchange your behaviour.Never reach into the machine while it is operating or runningdown.Keep children and visitors a safe distance from the work area.Never leave a running machine unattended. Before you leavethe workplace switch off the machine.Do not operate the electric tool near inflammable liquids orgases.Observe the fire fighting and fire alert options, for example thefire extinguisher operation and place.Do not use the machine in a dump environment and do notexpose it to rain.Wood dust is explosive and can also represent a risk to health.Dust form some tropical woods in particular, and fromhardwoods like beach and oak, is classified as a carcinogenicsubstance.Always use a suitable dust extraction deviceBefore machining, remove any nails and other foreign bodiesfrom the workpiece.Use a push block when working the ends of narrow stock.Always store the push stick or the push wood handle with themachine, also when not in use.Specifications regarding the maximum or minimum size of theworkpiece must be observed.Do not remove chips and workpiece parts until the machine isat a complete standstill.Never operate with the guards not in place – serious risk ofinjury!Do not stand on the machine.Connection and repair work on the electrical installation may becarried out by a qualified electrician only.Make all machine adjustments or maintenance with themachine unplugged from the power source.Have a damaged or worn cord replaced immediately.Remove defective saw blades immediately.3.3 Remaining hazardsWhen using the machine according to regulations someremaining hazards may still exist