Jet JWCS-10 Owner's Manual

Also see for XACTA Fence II Homeshop 30: Owner's manual Owner's manual

Contents

7InstallationTools requiredDrill with 5/16" drill bit10mm open end wrenchesCross point screwdriverAdjustable squareHammer (or rubber mallet)Straight edgeThe following instructions are for installing theXACTA Fence II and Rail System on JET ModelsJWCS-10 and JWTS-10 series table saws.Front Rail InstallationReferring to Figures 1:1. With a 5/16” drill bit, drill out the two threadedholes on the table front (C).Note: By drilling out the threads you will gainthe needed room for adjustment of the frontrail.2. Identify the front rail (A), which is 2” x 2” withslots running along each side.3. Align the slots on the front rail to the four holesin the front edge of the saw table (Figure 1).Referring to Figure 2:4. Lightly secure the front rail to the saw tableand extension wings with four 1/4-20 x 1-1/2hex cap screws, eight 1/4” flat washers, four1/4” lock washers, and four 1/4” hex nuts.Tighten just enough to hold the rail next to thetable but keep loose enough to allow heightadjustment.The front rail must be 2-3/16" down from the tabletop in order to function properly.5. Place an adjustable square on the table asshown in Figure 3.6. Check the height of the front rail at severallocations along the surface of the saw table.The front rail must be parallel with the tabletop.7. When the front rail has been correctlypositioned, tighten all mounting screwssecurely with two 10mm wrenches.Figure 1Figure 2Figure 3