Jeti Duplex DC16 User Manual
computer radio control system EN8.3. InstallationWhenever possible, you should wrap the receiver in foam and placeit as far as possible from sources of interference (servos, electricmotors). Arrange the receiver antennas so that their active ends forma 90° angle and try to put them as far as possible away from eachother. Take care not to bend them with a radius smaller than 1 cm.The active part of the antenna should not be placed close to metalparts. If your model has a carbon fuselage it is very important toplace the active antenna ends outside the fuselage.8.4. BindingIn order to achieve communication between transmitter andreceiver you must bind them. During this process the transmitterlearns the receiver address and will automatically find it again whenswitched back on. Communication begins with this receiverautomatically if the transmitter is not already communicating withanother receiver. The binding process needs only to be done oncefor each receiver.Procedure:1. Switch off the transmitter and receiver.2. Plug the „BIND PLUG“ into the EXT receiver input.3. Connect receiver power supply.4. Switch on the transmitter. The receiver will bind with theprimary transmitter module.3.3.8.5. Range TestThe range test will verify that the transmitter and receiver arefunctioning properly.Before the first flight of each flying session or if have any doubtsabout the transmitter or receiver function you should always checkthe range. During the range test the transmitter’s output power isdecreased to 10%.When performing a range test, both the model and the transmittershould be at a minimum height of 80 cm (31.5“) above the ground. Acorrectly functioning transmitter and receiver in range test modeshould safely control a model to a minimum distance of 50m (164‘).If not, check your model’s antenna installation first. If the test is stillnot successful don´t fly the equipment and contact your retail shopor one of the Jeti authorized service centers.8.6. Fail safeAll Duplex 2,4GHz system receivers are equipped with „fail safe“, afunction which reacts to control signal transmission interruptions.When your receiver for any reason does not receive transmitterinformation it changes, after a pre-set time period, to one of thefollowing modes.„Repeat“ – This mode holds the last valid control throw signal ( this isthe default mode for all receivers)„Out off“ – There is no output signal provided by the receiver, i. e.servos do not keep their positions„Failsafe“ – receiver outputs change to preset positions |
Related manuals for Jeti Duplex DC16
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine