Kärcher BD 50 C Ep Classic Manual

Also see for BD 50 C Ep Classic: Operation instructions Manual

Contents

- 4ATTENTIONRisk of damage to the floor covering. Donot operate the appliance on the spot.Î Insert the end of the extension cable asa loop in the strain relief clamp.Î Connect the mains plug of the device tothe extension cable.Î Insert the mains plug of the extensioncable into a socket.Î Turn the program selection switch tothe desired cleaning program.Î Operate the safety switch.Î Pull the lever out and press it down; thevacuum bar is lowered.Note:– For cleaning tiled floors, adjust thestraight suction bar in such a way thatcleaning is not done at an angle of 90degrees to the joints.– The inclined position and the inclinationof the suction bar can be adjusted toachieve better suction results (see "Ad-justing the suction bar").– If the waste water tank is full, the floatcloses the suction opening and the suc-tion turbine runs at an increased speed. Ifthis is the case, shut the vacuum off anddrive to empty the waste water tank.Î Close the regulatory button for settingthe water quantity.Î Briefly drive forward and suck of the re-maining water.Î Raise the vacuum bar.Î Set the programme selector switch to"OFF".Î Disconnect the mains plug from thesocket.n WARNINGPlease observe the local provisions regard-ing the wastewater treatment.Î Take the water discharge hose from thesupport and lower above a suited col-lection device.Î Crush or bend the dosing equipment.Î Open the lid of the dosing equipment.Î Drain off the dirt water - regulate thewater quantity by pressing or bending.Î Rinse the waste water tank with clearwater.Î Unscrew the lock of the fresh water res-ervoir.DANGERRisk of injury! When loading or unloadingthe machine, it may only be operated ongradients up to the maximum value (see"Technical Specifications"). Drive slowly.n CAUTIONRisk of personal injury or damage! Mind theweight of the appliance during transport.Î Press down and push the device usingthe push handle.Î When transporting in vehicles, securethe appliance according to the guide-lines from slipping and tipping over.n CAUTIONRisk of personal injury or damage! Consid-er the weight of the appliance when storingit.This appliance must only be stored in inte-rior rooms.DANGERRisk of injury! Set the programme selectorswitch to "OFF" and disconnect the mainsplug prior to performing any work on the de-vice.Î Drain and dispose of the dirt water andthe residual fresh water.ATTENTIONRisk of damage. Do not sluice the appli-ance with water and do not use aggressivedetergents.Î Drain off dirt water.Î Rinse the waste water tank with clearwater.Î Clean the outside of the appliance witha damp cloth which has been soaked inmild detergent.Î Check the fluff filter, clean if required.Î Clean the vacuum lips and the wipinglips, check for wear and replace if re-quired.Î Check the brush for wear and replace ifrequired (see "Maintenance tasks").Î Clean the seals between waste watertank and cover and check for tightness,replace if required.Î Have the prescribed inspection carriedout by the customer service.1 Wear indicator2 Vacuum lipThe vacuum lips must be replaced or re-versed if they are worn down to the wear in-dicator.Î Remove the vacuum bar.Î Unscrew the star grips.Î Remove the plastic parts.Î Remove the vacuum lips.Î Insert new or reversed vacuum lips.Î Insert the plastic parts.Î Screw in and tighten the star grips.Î Push down the device holding the pushhandle so that the cleaning head israised.Î Press the pedal for changing the brush-es downward beyond its resistance.CleaningLower the vacuum barShutting Down the ApplianceDrain off dirt waterDrain off clean waterTransportStorageCare and maintenanceMaintenance scheduleAfter each operationMonthlyYearlyMaintenance WorksReplace or turn vacuum lipsReplacing the disk brushes (1

/ 8

Related manuals for Kärcher BD 50 C Ep Classic