Kärcher HD 6/15-4 Operating Instructions Manual

Also see for HD 6/15-4: Service manual Manual Original instructions Manual Manual

Contents

Kärcher HD 6/15-4 Operating Instructions Manual Manual pdf 19 page image

– 5– Check the contents of the pack beforeunpacking.– In case of transport damage inform ven-dor immediately. The oil level must be at the centre of theoil level display. Open the device hood. Unscrew the screw plug. Screw in oil filling screw. Close cover. Adjust the push handle on the appli-ance. Secure the push handle by means ofthe mushroom head bolts and the starknobs. Connect spray lance to trigger gun. Install nozzle with nozzle screw at thespray lance. Bolt the high-pressure hose on to thehand spray gun. Fasten the high pressure hose to thehigh pressure connection. DangerDanger of injury by electric shock.The appliance may only be connected to al-ternating current.The highest allowed net impedance at theelectrical connection point (refer to techni-cal data) is not to be exceeded. In case ofconfusion regarding the power impedancepresent on your connection, please contactyour utilities provider.The appliance should always be connectedto the electrical mains using a plug. It is for-bidden to permanently connect the appli-ance to the power supply. The plug is onlyfor mains separation.Use the extension cord that has an ade-quate cross-section (see "Technical Data")and unwind it fully from the cable drum.For connection values, see type plate/tech-nical data. WarningObserve regulations of water supplier.According to the applicable regula-tions, the appliance must never beused on the drinking water supplywithout a system separator. Use asuitable system separator manufactured byKÄRCHER; or, as an alternative, a systemseparator as per EN 12729 Type BA. Waterflowing through a system separator is con-sidered non-drinkable.CAUTIONAlways connect the system separator tothe water supply, never directly to the appli-ance!For connection values refer to technicalspecifications Connect the supply hose (minimumlength 7.5 m, minimum diameter 3/4“) tothe water connection point of the ma-chine and at the water supply point (fore.g. a tap).NoteThe supply hose is not included. Open the water supply. Screw the suction hose onto the waterconnection.Note:If a suction hose with a check valve or filteris used, the hose must be filled with water. Deaerate the appliance:Unscrew the nozzle.Before StartupUnpackingCheck oil levelActivate deaeration of oil containerInstalling the pushing handleAttaching the AccessoriesStart upElectrical connectionWater connectionConnection to the water supplyDrawing in water from open reservoirs19EN