Kärcher HDS 5/11 U/UX Manual

Also see for HDS 5/11 U/UX: Instructions Manual Manual Instruction manual

Contents

Kärcher HDS 5/11 U/UX Manual Manual pdf 17 page image

– 4 DANGERRisk of injury! Switch the appliance off prior to replacingnozzle and activate hand spray gun until device is pres-sureless. Secure the trigger gun. To do so, push the safetycatch towards the front. Replacing the nozzle.Illustration1 Operating with cold water2 Operating with hot water Set appliance switch to desired operating mode.The device starts briefly and turns off, as soon as theworking pressure is reached. Release the trigger gun. To do so, push the safetycatch towards the back.When activating the hand spray gun the device switch-es back on.Note: If no water comes out of the high pressure nozzle,vent pump.Vent pump: With open hand spray gun turn device on and offmultiple times with the device switch.Note: By dismantling the spray lance from the handspray gun, the venting process is accelerated. Release the pulling lever; the device will switch off.Secure the trigger gun. To do so, push the safetycatch towards the front. Release the trigger gun. To do so, push the safetycatch towards the back.Release the pulling lever again; the device willswitch on again. Close the hand spray gun. Secure the trigger gun. To do so, push the safetycatch towards the front. Turn the casing of the nozzle till the desired symbolmatches the marking.– For considerate treatment of the environment usedetergent economically.– The detergent must be suitable for the surface tobe cleaned.Illustration Take out detergent suck hose. Turn filter on the detergent suction hose in order todispense the detergent. Suspend end of suction hose in a container filledwith detergent. Set nozzle to "CHEM". Set the detergent concentration according to thesurface to be cleaned.Note: To prevent damage due to too much pressure, al-ways position high pressure ray first from a greater dis-tance towards object to be cleaned.– Loosen the dirt: Spray detergent economically and let it work for1...5 minutes but do not let it dry up.– Remove the dirt: Spray off loosened dirt with the high pressure jet.Removal of light contaminations and clear rinse, i.e.:Gardening tools, terrace, tools, etc. Set the appliance switch to "1". DANGERScalding danger! Set the appliance switch to "2". Completely close the filter at the detergent suctionhose (-). Set the appliance switch to "1". Open the hand spray gun and rinse the appliancefor at least 1 minute. DANGERDanger of scalding from hot water! After operation withhot water, the device must be operated with openedhandgun with cold water for at least two minutes. Shut off water supply. Open the hand spray gun. Switch on the pump with the power switch and al-low to run for about 5-10 seconds. Close the hand spray gun. Set the appliance switch to "0/OFF“. Pull main plug out of socket with dry hands only. Remove water connection. Activate hand spray gun until device is pressureless. Secure the trigger gun. To do so, push the safetycatch towards the front.Replace the nozzleOperating modes0/OFF = OffTurning on the ApplianceInterrupting operationSelect spray typeHigh pressure circular spray (0°) forspecially stubborn dirtFlat low pressure spray (CHEM) for op-erating using detergents or cleaning atlow pressure.High pressure flat spray (25°) for largedirt areasOperation with detergentCleaningRecommended cleaning methodOperating with cold waterOperating with hot waterAfter operation with detergentTurn off the appliance17EN