Kärcher HDS 6/10 C/CX Instructions Manual

Kärcher HDS 6/10 C/CX Instructions Manual Manual pdf 29 page image

– 5Note: Push the bottle in securely to pene-trate the closure. Do not remove bottle untilit is empty.– The system care prevents the calcifica-tion of the heating spiral while operatingwith calciferous tap water. It is dosedinto the supply in the float containerdrop by drop.– The metering is set to medium water ri-gidity by the manufacturerNote: A system care bottle is included inthe delivery. Replace the system care bottle. DangerRisk of explosion! Only refill diesel oil orlight fuel oil. Unsuitable fuels, e.g. petrol,are not to be used.CautionNever operate device with empty fuel tankThe fuel pump will otherwise be destroyed. Refill fuel. Close tank lock. Wipe off spilled fuel.CautionRisk of injury!– Use Kärcher products only.– Under no circumstances fill solvents(petrol, aceton, diluting agent etc.)– Avoid eye and skin contact.– Observe safety and handling instruc-tions by the detergent manufacturer.Kärcher offers an individual cleaningand care appliances program.Your dealer will consult you gladly. Refill detergent.For connection values refer to technicalspecifications Attach supply hose (minimum length7.5 m, minimum diameter 3/4“) to thewater supply set by means of a hoseclamp. Connect the supply hose to the waterconnection point of the machine and atthe water supply point (for e.g. a tap).Note: The supply hose and the hose clampare not included in the scope of delivery.If you want to suck in water from an exter-nal vessel, the following modification isnecessary: Remove the system care bottle.Figure 9 Remove the two screws on the burnercasing.Figure 10 Unscrew the back wall and remove it.The nozzle of the system care reservoirwill remain in the back wall.Figure 11 Remove water connection from the finefilter. Unscrew the fine filter from the pumphead. Remove the system care reservoir.Figure 12 Unscrew the top supply hose to theswimmer container. Connect the top supply hose at pumphead. Replug the rinse line of the detergentdosing valve to blind plugs. Connect suction hose (minimum diame-ter 3/4“) with filter (accessory) to thewater connection point.– Max. suck height: 0.5 mUntil the pump sucked in water, you should: Set the pressure/quantity regulation atthe pump unit to maximum quantity. Close the dosing valve for the deter-gent.Replace the system care bottleRefill fuelRefill detergentWater connectionSuck in water from vessel29EN