– 7For longer work breaks or if a frost free stor-age is not possible: Drain water. Flush device with anti-freeze agent. Empty detergent tank. Screw off water supply hose and highpressure hose. Screw off supply hose at boiler bottomand drain heating spiral empty. Operate device for max. 1 minute untilthe pump and conduits are empty.Note: Observe handling instructions of theanti-freeze agent manufacturer. Use commercially available anti-freezeagent. Switch on appliance (without heater) tillthe appliance has been completelyrinsed.A certain corrosion protection is achievedwith this as well.CautionRisk of injury and damage! Note the weightof the appliance in case of storage.Figure 7CautionRisk of damage! When loading the appli-ance with a forklift, observe the illustration.CautionRisk of injury and damage! Observe theweight of the appliance when you transportit. When transporting in vehicles, securethe appliance according to the guide-lines from slipping and tipping over. DangerRisk of injury by inadvertent startup of ap-pliance and electrical shock.First pull out the plug from the mains beforecarrying out any tasks on the machine. Set the appliance switch to "0/OFF“. Shut off water supply. Open the hand spray gun. Turn on pump shortly (appr. 5 seconds)with device switch. Pull main plug out of socket with dryhands only. Remove water connection. Activate hand spray gun until device ispressure less. Lock the trigger gun. Allow device to cool down.Your Kärcher vender will inform youabout the performance of a periodicsafety inspection resp. signing of amaintenance contract. Clean the sieve in the water connection. Clean the fine filter. Clean the fuel sieve. Check oil level.CautionIn case of lacteous oil inform Kärcher cus-tomer service immediately Clean sieve in the water shortage safeguard. Clean filter at the detergent suck hose. Oil change.ShutdownDump waterFlush device with anti-freeze agentStorageTransportMaintenance and careMaintenance intervalsWeeklyMonthlyAfter 500 operating hours, at least annu-ally22 EN