Kärcher HDS 7/11-4 M Instruction Manual

Also see for HDS 10/20-4 M: Manual Instructions User manual Original instructions Manual

Contents

Kärcher HDS 7/11-4 M Instruction Manual Manual pdf 14 page image

– 9 Lock in the steel pipe into the holder ofthe appliance hood. Roll up high pressure hose and electri-cal conduit and hang them into the re-spective holders.Device with hose drum: Before rolling up, stretch out the highpressure hose. Turn the hand crank clockwise (Direc-tion of the arrow).Note: Do not twist high pressure hose andelectrical conduit.CautionFrost will destroy the not completely waterdrained device. Store in a frost free area.If the device is connected to a chimney, thefollowing must be observed:CautionThreat of damage by penetrating cold airthrough the chimney. Disconnect device from chimney whenoutside temperature drops below 0 °C.If it is not possible to store frost free, shutdown device.For longer work breaks or if a frost free stor-age is not possible: Drain water. Flush device with anti-freeze agent. Empty detergent tank. Screw off water supply hose and highpressure hose. Screw off supply hose at boiler bottomand drain heating spiral empty. Operate device for max. 1 minute untilthe pump and conduits are empty.Note: Observe handling instructions of theanti-freeze agent manufacturer. Fill anti-freeze agent of the trade intoswimmer container. Switch on appliance (without heater) tillthe appliance has been completelyrinsed.A certain corrosion protection is achievedwith this as well.CautionRisk of injury and damage! Note the weightof the appliance in case of storage.Figure 11CautionRisk of damage! When loading the appli-ance with a forklift, observe the illustration.CautionRisk of injury and damage! Observe theweight of the appliance when you transport it. When transporting in vehicles, securethe appliance according to the guide-lines from slipping and tipping over. DangerRisk of injury by inadvertent startup of ap-pliance and electrical shock.First pull out the plug from the mains beforecarrying out any tasks on the machine. Set the appliance switch to "0/OFF“. Shut off water supply. Turn on pump shortly (appr. 5 seconds)with device switch. Pull main plug out of socket with dryhands only. Remove water connection. Activate hand spray gun until device ispressure less. Lock the trigger gun. Allow device to cool down.Your Kärcher vender will inform youabout the performance of a periodicsafety inspection resp. signing of amaintenance contract.Storing the ApplianceFrost protectionShutdownDump waterFlush device with anti-freeze agentStorageTransportMaintenance and care32 EN