Basic Settings and Service Procedures HDS Middle Range / HDS Premium RangePage 102 / 127 Service Manual 04.20083.7 Removing the hose reel3.7.2 Replacing the rotating union seal(continued)– Only if necessary: Undo the high-pressureline (1) using open-end spanner (SW 27) andremove the two screws in the rear bearingblock (see page 101 Item 10 and 11).– Re-install the hose reel. Push rear hose reelshell (3) onto axle, insert connection piece (4)and install circlip (5). Move hose reel into thedisplayed position.– Insert front hose reel half-shell (6) with crank(7) and ensure it is correctly positioned.– Install the two countersunk screws (8).– Turn hose reel (6) through 180° and installanother countersunk screw (see page 100,Item 1).– Install front bearing block with four screws.– Insert new hose through the hose guideprovided and the deflection pulley on theunderside of the unit.– Completely push the hose nipple into theconnection piece of the hose reel and securewith clip (see page 99, Item 3).– Re-install the second half-shell (see page 99,Item 1).125 34678Undo high-pressure lineRear hose reel shellConcealed screws in front half-shell1 High-pressure line to the connectionpiece2 Open-ended spanner (SW 27)3 Hose reel, rear shell4 Connection piece5 Axle, hose reel6 Half-shell, hose reel7 Crank
