9.800-088.0 • REV. 0/0811PRESSURE WASHER OPERATOR’S MANUALOIL CHANgE RECORDPREvENTATIvE MAINTENANCEThis pressure washer was produced with the best available materials and quality craftsmanship. However, youas the owner have certain responsibilities for the correct care of the equipment. Attention to regular preventativemaintenance procedures will assist in preserving the performance of your equipment. Contact your dealer formaintenance. Regular preventative maintenance will add many hours to the life of your pressure washer. Performmaintenance more often under severe conditions.general Inspection Inspect the motor at regular intervals, approximately every 500 hours of operation,or every 3 months, whichever occurs first. Keep the motor clean and the ventilationopenings clear. The following steps should be performed at each inspection:WARNINg: Do not touch electrical connections before you first ensure that powerhas been disconnected. Electrical shock can cause serious or fatal injury. Onlyqualified personnel should attempt the installation, operation and maintenance ofthis equipment.1. Check that the motor is clean. Check that the interior and exterior of the mo-tor is free of dirt, oil, grease, water, etc. Oily vapor, paper pulp, textile lint, etc.can accumulate and block motor ventilation. If the motor is not properly ven-tilated overheating can occur and cause early motor failure.. Check all electrical connectors to be sure that they are tight.Lubrication & bearings Bearing grease will lose its lubricating ability over time, not suddenly. The lubricatingability of a grease (over time) depends primarily on the type of grease, the size ofthe bearing, the speed at which the bearing operates and the severity of the operat-ing conditions. Good results can be obtained if the following recommendations areused in your maintenance program.Type of grease A high grade ball or roller bearing grease should be used. Recommended greasesstandard service conditions are: Shell Dolium R (Factory installed) or ChevronSRIPump Oil Inspect Daily, Inspect the oil levelChange After first 50 hours, then every 500 hoursor annuallyReplace High Pressure Nozzle Every 6 monthsReplace Quick Connects AnnuallyReplace Clean Water Screen/Filter WeeklyReplace HP Hose Annually if there is any sign of wearGrease Motor Every 10,000 hours or annuallyDate Oil ChangedMonth/Day/yearEstimated OperatingHours Since LastOil ChangeDate Oil ChangedMonth/Day/yearEstimated OperatingHours Since LastOil Change