Kärcher K 2.300 Manual

Also see for K 2.300: Operating instructions Operator's manual User manual Manual Operating instructions

Contents

– 7Mount loose parts delivered with appliance priorto start-up.Illustrations on Page 3Illustration Insert the transport wheels and lock them.Illustration Attach the transport handle /carrying handle.Illustration Pull out the clamp for the high-pressure hosefrom the hand spray gun (e.g. a Philipsscrewdriver).Illustration Connect high pressure hose to trigger gun. Push the clamp in until it locks. Check the se-cure connection by pulling on the high-pres-sure hose.OptionalIllustration Pull the suction hose for detergent throughthe cover of the detergent tank until the filtercontacts the bottom of the tank. Close the detergent tank with the lid. Lock the detergent tank in place on the appli-ance.Illustration Hook the accessories net into the hooksshown in the illustration.According to the applicable regula-tions, the appliance must never beused on the drinking water supply with-out a system separator. Use a suitablesystem separator manufactured by KÄRCHER;or, as an alternative, a system separator as perEN 12729 Type BA. Water flowing through a sys-tem separator is considered non-drinkable.CautionAlways connect the system separator to the wa-ter supply, never directly to the appliance!Note: Impurities in the water can damage thehigh-pressure pump and accessories. For pro-tection, the use of the KÄRCHER water filter (op-tional accessory, order no. 4.730-059) isrecommended.Observe regulations of water supplier.For connection values, see type plate/technicaldata. Use a fibre-reinforced water hose (not in-cluded) with a standard coupling. (Minimumdiameter 1/2 inch (13 mm), minimum length7.5 m).Illustration Screw the coupling element to the waterconnection on the appliance. Push the water supply hose onto the cou-pling unit, then connect it to the water supply.CautionDry runs lasting longer than two minutes lead todamages to the high pressure pump. If the appli-ance does not build up pressure within two min-utes, switch it off and proceed as instructed inthe Chapter "Troubleshooting".Illustration Connect the high pressure hose to the highpressure connection of the appliance.Illustration Push the spray lance into the trigger gun andfasten it by turning it through 90°. Completely open the water tap. Insert the mains plug into the socket. Turn on the appliance “I/ON”. DangerThe trigger gun is subjected to a recoil forcewhen the water jet is discharged. Make sure thatyou have a firm footing and are also holding thetrigger gun and spray lance firmly.Illustration Unlock the lever on the trigger gun. Pull on the lever of the trigger gun; the devicewill switch on.Note: Release the lever of the trigger gun; thedevice will switch off again. High pressure re-mains in the system.For normal cleaning tasks.Not suitable for use with detergents.For particularly dirty items or areas.Not suitable for use with detergents.Carrying out the most common cleaning tasks.The work pressure can be stagelessly regulatedbetween "Min" and "Max". You can add deter-gent when "Mix" is selected. Release the lever on the trigger gun.Illustration Turn the spray pipe to the desired position.Before StartupWater supplyWater supply from mainsStart upOperationSpray lance with high pressure nozzleSpray lance with DirtblasterSpray lance with pressure regulation (VarioPower)14 EN