Kärcher K 3.97 M Manual

Also see for K 4.86 M: Operating instructions Operating instructions Operating instructions Original instructions Manual

Contents

- 4The scope of delivery of your appliance is il-lustrated on the packaging. Check the con-tents of the appliance for completenesswhen unpacking.In the event of missing accessories or anytransport damage, please contact yourdealer.These operating instructions describe themaximum equipment. Depending on themodel, there are differences in the scopesof delivery (see packaging).Illustrations on Page 21 Coupling element for water connection2 High pressure connection3 Appliance switch "0/OFF“/ „I/ON“4 Storage for trigger gun5 Transport handle6 Storage for accessories7 Mains cable with mains plug8 Suction hose for detergent9 Connection for water supply with filter10 Trigger gun11 Lock trigger gun12 High pressure hose13 Spray lance with Dirtblaster14 Spray lance with pressure regulation(Vario Power)Special accessories expand the possibili-ties of using your appliance. Please contactyour KÄRCHER dealer for further informa-tion.IllustrationMount loose parts delivered with applianceprior to start-up.Illustration Push the high pressure hose into thetrigger gun until it locks audibly.Note: Make sure the connection nippleis aligned correctly. Check the secure connection by pullingon the high-pressure hose. WarningAccording to the applicable regula-tions, the appliance must never beused on the drinking water supplywithout a system separator. Use asuitable system separator manufactured byKÄRCHER; or, as an alternative, a systemseparator as per EN 12729 Type BA. Waterflowing through a system separator is con-sidered non-drinkable.CautionAlways connect the system separator tothe water supply, never directly to the appli-ance!Note: Impurities in the water can damagethe high-pressure pump and accessories.For protection, the use of the KÄRCHERwater filter (optional accessory, order no.4.730-059) is recommended.Observe regulations of water supplier.For connection values, see type plate/tech-nical data. Use a fibre-reinforced water hose (notincluded) with a standard coupling.(Minimum diameter 1/2 inch (13 mm),minimum length 7.5 m). Screw the coupling element (supplied)to the water connection on the appli-ance. Push the water supply hose onto thecoupling unit, then connect it to the wa-ter supply.This high-pressure cleaner is suited to workwith the KÄRCHER suction hose with back-flow valve (Optional accessory, order no.4.440-238) to draw in surface water, e.g.from water butts or ponds (see specifica-tions for max. suction height). Fill the KÄRCHER suction hose withbackflow valve with water, screw to wa-ter supply and hang into the water butt.OperationScope of deliveryDescription of the ApplianceSpecial accessoriesBefore StartupWater supplyWater supply from mainsDrawing in water from open reservoirs14 EN