Kärcher K2.93 Operating Instructions Manual

Also see for K 2.93: Manual Original instructions Operator's manual Original instructions

Contents

Kärcher K2.93 Operating Instructions Manual Manual pdf 10 page image

10 English! Warning: Vehicle tyres or tyre valves aresusceptible to damage from the high-pressure jet and may burst. The first indi-cation of this is a discolouration of thetyre. Damaged vehicle tyres or tyrevalves endanger life. Ensure that a dis-tance of at least 30 cm is observed whencleaning with the jet!! Cleaning operations which produce oilywaste water, e.g. engine washes, under-body washes, may only be carried outusing washing stations equipped with anoil separator.! Observe a distance of at least 30 cmwhen using the jet to clean painted sur-faces to avoid damaging paintwork.! Never draw in fluids containing solventsor undiluted acids and solvents! This in-cludes petrol, paint thinner and heatingoil. The spray mist thus generated ishighly inflammable, explosive and poi-sonous. Do not use acetone, undilutedacids and solvents as they are aggres-sive towards the materials from whichthe appliance is made.! Wear suitable clothing and goggles toprotect against back spray containingwater or dirt.! Never leave the appliance unattendedwhen it is in operation.! Warning: This appliance was designedto be used with detergents which aresupplied or recommended by the manu-facturer. The use of other detergents orchemicals may compromise the safety ofthe appliance. Electrical connection! Make sure that the power cord or exten-sion cables are not damaged by runningover, pinching, dragging or similar. Pro-tect the power cords from heat, oil, andsharp edges.! Never use a defective power cord or ex-tension cable! If the power cord is dam-aged it must be replaced with a specialpower cord available from the manufac-turer or his customer service.! Never touch the mains plug and thesocket with wet hands.! The connection between the power cordand extension cable must not lie in wa-ter.! All current-conducting parts in the work-ing area must be protected against jetwater.! The appliance may only be connected toan electrical supply which has been in-stalled in accordance with IEC 60364.! The appliance may only be connected toalternating current. The voltage mustcorrespond with the type plate on the ap-pliance.! The minimum fuse rating required at thesokket outlet is 10 A (slow-blow).! To avoid accidents due to electricalfaults we recommend the use of socketswith a line-side current-limiting circuitbreaker (max. 30 mA nominal trippingcurrent).! Warning: Unsuitable extension cablescan be hazardous. Only use extensioncables outdoors which have been ap-proved for this purpose and labelled witha sufficient cable cross-section:1 -10 m: 1.5 mm210 - 30 m: 2.5 mm2! The plug and coupling of the extensioncable used must be watertight.! Always fully unroll the extension cablefrom the cable drum.Safety devices prevent injury and may notbe modified or bypassed.The switch prevents unintended starting ofthe appliance. Stop the appliance duringbreaks or after operation.The safety catch on the handgun preventsthe appliance from being switched on unin-tentionally.Safety DevicesUnit switchSafety catch