Kärcher SC 4 EasyFix Manual

Also see for SC 4 Premium: Manual Quick reference Manual Manual Manual

Contents

Kärcher SC 4 EasyFix Manual Manual pdf 7 page image

12 English29 Extension tubes (2 x)30 Unlocking button31 Floor nozzle32 Hook and loop fastener33 Microfibre floor cloth (1 x)34 ** Microfibre floor cloth (2 x)35 ** Carpet glider** optionalInstallationInstalling accessories1. Insert and engage the steering roller and non-drivenwheels.Illustration B2. Push the open end of the accessory onto the steamgun so that the unlocking button on the steam gunengages.Illustration I3. Push the open end of the accessory onto the spot-light nozzle.Illustration J4. Connect the extension tubes with the steam gun.a Push the first extension tube onto the steam gunso that the unlocking button on the steam gun en-gages.The connection pipe is connected.b Push the second extension tube onto thefirst extension tube.The connection pipes are connected.Illustration K5. Push the accessory and / or the floor nozzle onto thefree end of the extension tube.The accessory is connected.Disconnecting accessories1. Set the selector switch for the steam volume to therear.The steam lever is locked.2. Push the unlocking button and pull the parts apart.Illustration QOperationFilling waterThe water reservoir can be removed at any time for fill-ing or be filled directly at the device.ATTENTIONDamage to the deviceUnsuitable water can block the nozzles or damage thewater level indicator.Do not fill in pure distilled water. Use a maximum of 50%distilled water mixed with tap water.Do not use condensation from the clothes dryer for fill-ing.Do not use collected rain water for filling.Do not use cleaning agents or other additives (e.g.scents) for filling.Remove the water reservoir for filling1. Pull the water reservoir vertically upwards.Illustration C2. Fill the water tank vertically with tap water or a mix-ture of tap water and no more than 50% distilled wa-ter up to the "MAX" mark.3. Insert the water reservoir and press downwards untilit locks into place.Filling the water reservoir directly on the device1. Fill tap water or a mixture of tap water and no morethan 50% distilled water from a vessel into the fillinghole of the water reservoir up to the "MAX" mark.Illustration DSwitch on the deviceNoteIf there is no or too little water in the steam boiler, thewater pump starts to run and pumps water from the wa-ter reservoir into the steam boiler. The filling processcan take several minutes.NoteThe device briefly closes the valve every 60 secondscausing an audible soft click. Closing prevents the valvefrom clogging. This does not affect the steam output.1. Place the device on a firm surface.2. Insert the mains plug into a socket.Illustration E3. Press the ON switch.The green heating indicator light flashes.Illustration F4. Wait until the green heating indicator stays on.Illustration G5. Press the steam lever.Illustration HSteam leaks out.Regulating the steam volumeThe expelled steam volume is regulated using the se-lector switch for steam volume. The selector switch has3 positions:1. Set the selector switch for the steam volume to re-quired steam volume.2. Press the steam lever.3. Before starting cleaning, point the steam gun at acloth until steam is expelled evenly.Refilling waterIf there is not enough water, the water shortage indicatorlamp flashes red and a signal tone sounds.NoteThe water pump fills the steam boiler at intervals. If thefilling is successful, the red water shortage indicatorlamp goes out.NoteIf there is no or too little water in the steam boiler, thewater pump starts to run and pumps water from the wa-ter reservoir into the steam boiler. The filling processcan take several minutes.ATTENTIONDamage to the deviceUnsuitable water can block the nozzles or damage thewater level indicator.Maximum steam volumeReduced steam volumeNo steam - child lockNoteIn this position, the steam lever cannotbe operated.