Kärcher SE 4002 Manual

Also see for SE 4002: Original instruction Original instructions Manual

Kärcher SE 4002 Manual Manual pdf 18 page image

– 10 Rinse the spray tubes in the applianceas follows:Fill the detergent container with about 1liter of clear water.Hold the nozzle above the drain, andswitch on the spraying pump until theclear water has been consumed. CautionAlways work with the filter bag inserted, ex-cept when a cartridge filter is used (option).The reservoir and accessories must be dryto prevent parts from sticking together.Illustration Insert a filter bag.Illustration Use the adapter for wet/dry vacuumingAttach the adapter to the handle, turnthe locking handle to secure it. Select the desired accessories and at-tach to the spray/suction pipes or direct-ly to the attachment. Switch on suction (position I).Illustration Insert the hard surface inlay into thefloor nozzle. The bristles should pointtowards the front.Illustration Work without the hard surface insert. Use the surrounding air separator toadapt the suction force.Note: Close the surrounding air separa-tor again after use! CautionDo not use a filter bag!Immediately switch the appliance off or pullthe power plug if foam forms or liquids es-cape!Note: If the container is full a float closes thesuction opening and the appliance works ata higher speed. Switch off the appliance im-mediately and empty the container. Use wash nozzles to vacuum moistureor wetness.If you use a crevice nozzle: Attach and secure the adapter for wet/dry vacuuming. Install the crevice noz-zle directly to the adapter. Switch on suction (position I).Illustration Open the surrounding air separator ifwater is suctioned from a tank. Close itagain after use. Empty the full reservoir (refer to chapter"Empty reservoir"). Turn off the appliance. Empty the full reservoir (refer to chapter"Empty reservoir"). Rinse the reservoir thoroughly withclear water. Separate the handle, the spray/suctionhoses and the wash nozzle from eachother; open locking lever to achieve this(centre position), Flush the accessories separately underrunning water and let air dry. Clean the foam filter under running wa-ter; let it dry before reinserting it. Leave the appliance open to let it dry. Storing the appliance. Store the ac-cessories on the appliance and store indry rooms.End wet cleaning processDry vacuum cleaningVacuuming hard surfacesVacuuming carpeted floorsWet vacuum cleaningShutting down18 ENDownloaded From Vacuum-Manual.com Manuals