Kärcher WD 3 Operating Instructions Manual

Contents

before startup

Kärcher WD 3 Operating Instructions Manual Manual pdf 13 page image

– 8Recommendation: In order to vacuum the floor, attachthe handle to the suction hose.Illustration Connect the handle with the suction hose until itsnaps in place.Illustration To remove the handle from the suction hose, pressthe notch using your thumb and pull off the handle.Note: Due to removing the handle, accessories can bedirectly attached to the suction hose.Recommendation: In order to vacuum the floor, attachthe handle to the suction hose.See position 13.Illustration Put both suction tubes together and connect themwith the handle. For edges, joints, heaters and hard to reach loca-tions.IllustrationFor appliances with only one insert: Note: For vacuuming dry dirt or water off the floor -always work with the insert (brush strip and rubberlip) in the floor nozzle.For appliances with two inserts: When vacuuming dry dirt off the floor, clip an insertwith two brush strips into the floor nozzle. When vacuuming water off the floor, clip an insertwith two rubber lips into the floor nozzle.Illustration To connect the suction hose with an electric tool Adapt the adapter to the connection diameter of theelectric tool using a knife if necessary.ATTENTIONAlways work with an inserted cartridge filter during wetas well as dry vacuum cleaning!Illustration Mount loose parts delivered with appliance prior tostart-up.Illustration Connect accessories.Illustration Plug in the mains plug.Illustration Turn on the machine.ATTENTIONCheck the filter for damage prior to installation and re-place as necessary.Work with a dry cartridge filter only!Illustration Recommendation: To vacuum fine dust, use thefilter bag.– The filling level of the filter bag depends on the dirtthat is sucked in.– The filter bag needs to be replaced more frequentlywhile sucking in fine dust, sand, etc.– Clogged filter bags can burst - therefore make sureto replace the filter bag in a timely manner!ATTENTIONVacuum cold ashes only when using a pre-filter.Order no. basic design: 2.863-139.0, premium design:2.863-161.0. For vacuuming up moisture or wetness pay atten-tion to the correct floor nozzle insert and connectthe corresponding accessories.ATTENTIONDo not use a filter bag!Note: If the container is full, a float closes the suctionopening, and the appliance works at a higher speed.Switch off the appliance immediately, and empty thecontainer.Illustration Adapt the adapter to the connection diameter of theelectric tool using a knife if necessary. Connect the adapter to the handle of the suctionhose and connect it to the electric tool connection.Connect the mains plug of the electric power tool tothe vacuum cleaner.Illustration Switch the vacuum cleaner to Position II and startworking.Removable handleSuction tubes 2 x 0.5 mCrevice nozzleFloor nozzle(with inserts)AdapterOperationBefore StartupStart upDry vacuum cleaningInformation filter bagWet vacuum cleaningWorking with electrical power tools13EN