Stretch masking tape across the joint in such away as to apply pressure to the joint. Lay thewing flat. DO NOT DISTURB THE WINGUNTILL THE EPOXY HAS FULLEY CURED.FUSELAGE ASSEMBLYLocate and insert a pin in the firewall on the topof the fuselage.Remove the elevators from the stabilizer. Locateand draw a line down the center of the stabilizer.Looking through the rudder slot for the line,center the stabilizer in the fuselage. Using a pieceof string go back and forth between the ends ofthe stabilizer adjusting it till it is centered andsquare to the fuselage. DO NOT GLUEUse a felt tip pen to mark the outline of thefuselage on both the top and bottom of thestabilizer. Remove the stabilizer. Cut through thecovering about 1/8-inch inside the lines andcarefully remove the covering exposing the wood.{Be careful not to cut into the wood, as thiswould weaken the structure}4

wing assembly

KANGKE INDUSTRIAL FUN-50 Assembly Manual