KD Scientific KDS100 User Manual
              | |
7RATE can be selected from the main menu or will be displayed automatically after theVolume setting.The display reads: Rate: X.X ul/h or X.X ml/hRate units are ul/h or ml/h, microliter or milliliter/hour and are selected automaticallyfrom the syringe diameter.1) Use the arrow keys to display the flowrate required.2) Enter the rate with the select key.3) If the rate entered is out of range, a message is displayed:" Max Rate XX ml/h"To continue enter a lower rate ,or select a larger syringe.note: a. If a dispense volume was set then the display will now change to"Volume : 0.0" ,that is, in automatic dispense mode.When the pump runs the actual dispensed volume will be displayed and willincrement until the set volume is reached, at which time the pump will stopautomatically.b. If no dispense volume is set the LCD displays the set flowrate and,when running, the directional indicator arrow will pulse.START THE PUMPa. Press the run/stop key to start the pump. A second press will stop the pump.b. If the pump is stopped during a dispense the volume accumulator is not cleared - thedispense is paused. Restarting the pump with a second press of the run/stop keycontinues the dispense to the target volume.POWER FAILURE MODEIf there is a temporary power interruption, when no dispense volume is selected, the Power Uprun/stop option allows the pump to either resume the dispense when the power returns, orremain stopped but display a message warning of the power failure.1) Move the main menu to the right and select PWR UP.2) The display will read Power Up Run ( or STOP ). Use the arrow keys to change displayand select the required optionRun After power is returned the pump resumes normal operation. The display flashesPowerFailed to acknowledge a power interruption. Press Select to display the Rate.STOP Pump does not run when power returns. The LCD displays the rate setting.If a dispense volume is entered the power interruption stops the pump, clears the volumeaccumulator and returns the volume to the setpoint. Only if the power failure setting is “run” willthe power failure warning be displayed.CHANGE OR REVIEW VOLUME SETTING WHILE RUNNINGWhile the pump is running it is possible to look at the volume and flowrate settings withoutinterrupting the operation of the pump. If required the volume and flowrate settings can be |
manualsdatabase
Your AI-powered manual search engine