GB - 31AnnexAnnex BB.1 CertificationB.1.1 CE MarkingCE marked frequency inverter and servo drives were developed and manufactured to complywith the regulations of the Low-Voltage Directive 2006/95/EC.The inverter or servo drive must not be started until it is determined that the installation com-plies with the Machine directive (2006/42/EC) as well as the EMC-directive (2004/108/EC)(note EN 60204).The frequency inverters and servo drives meet the requirements of the Low-Voltage Directive2006/95/EC. They are subject to the harmonized standards of the series EN 61800-5-1.This is a product of limited availability in accordance with IEC 61800-3. This product maycause radio interference in residential areas. In this case the operator may need to take cor-responding measures.B.1.2 UL MarkingAcceptance according to UL is marked at KEB inverters with the adjacentlogo on the type plate.To be conform according to UL for use on the North American and Canadian Market the fol-lowing additionally instructions must be observed (original text of the UL-File):• For control cabinet mounting as „Open Type“• „Only for use in WYE 480V/277V supply sources“• Operator and Control Board Rating of relays (30 Vdc.: 1 A)• Maximum Surrounding Air Temperature 45 °C (113 °F)• Overload protection at 130 % of inverter output rated current (see type plate)• Motor protection by adjustment of inverter parameters. For adjustment see applicationmanual parameters Pn.14 and Pn.15.• „Use 60/75°C Copper Conductors Only“• Terminals - Torque Value for Field Wiring Terminals, the value to be according to the R/CTerminal Block used.• Use in a Pollution Degree 2 environment• ”Integral solid state short circuit protection does not provide branch circuit protection.Branch circuit protection must be provided in accordance with the Manufacturer Instruc-tions, National Electrical Code and any additional local codes”, or the equivalent”.further on next side