KEB Combivert F5 Installation Manual

Also see for COMBIVERT F5: INSTALLATION GUIDELINE Installation manual Instruction manual Instruction manual Installation manual

GB - 9Control2.2.1 LED1If the COMBIVERT F5 is operated without plugged operator, the inverter state can be readfrom integrated status LED..LED status Functionoff Unit switched offon Unit ready for operationflashing Unit in malfunction2.2.2 HSP5 interface X4AThe HSP5 interface X4A serves for the communication with a control operator. A digital op-erator, interface operator and different fieldbus operators are available for this. To preventmalfunctions, the inverter must be brought into nOP status before connecting / disconnectingthe operator (open control release terminal). When starting the inverter, it is started alwayswith the last stored values or factory setting.A special HSP5 cable (part number 00.F5.0C0-0010) is required for the operation of the KEBCOMBIVERT without operator. This cable is connected between HSP5 interface X4A andserial RS232 PC interface (COM1 or COM2). Operation occurs via the program COMBIVIS.The HSP5 service cable has an integrated level converter. The connection of a serialstandard cable would destroy the PC interface.2.2.3 Encoder interfaces X3A, X3BThe COMBIVERT F5 can be equipped optionally with encoder interfaces. Different combina-tions can be used here according to the requirements. The instruction is made separatelyaccording to the installed encoder interfaces.2.2.4 OperatorsThe COMBIVERT F5 can be equipped optionally with operator. Different control or field busoperators are available here according to the requirements. The instruction is made sepa-rately according to the installed operator.2.2.5 Control terminal strip X2AThe control terminal block X2A is designed as double, plug-in terminal block with spring cageconnection. It contains 32 pole.2.2.6 Safety terminal block X2BThe safety terminal block X2A is designed as double, plug-in terminal block with spring cageconnection. It contains 10 pole.