KEB Combivert F5 Instruction Manual

Also see for COMBIVERT F5: INSTALLATION GUIDELINE Installation manual Instruction manual Instruction manual Installation manual

Contents

Encoder interface HTL input / HTL outputGB-123.3.2 Output signals channel 2At the HTL encoder simulation the signal tracks A and B are electrically phase-shifted by90°. The output signals can be connected optionally as difference signal with the respectiveinverse tracks or as single-ended signals. The zero signal is output once per revolution withthe same level.Figure 3.2.2 Output signals HTLCOM+BCOM+At20…26 V20…26 V0 V0 VCOM-A 20…26 V0 VCOM-B 20…26 V0 V4. Start-upAfter the installation or exchange of an encoder interface some adjustments of the inverter/servo software have to be done before operation:• Switch on inverter• Select application mode• Select parameter Ec.0 and control whether value „15: inc. input with alarm24V HTL is entered. The displayed value has to be confirmed by „ENTER“ inany case.• Select parameter Ec.10 and control whether value „24: inc.input simulation“ isentered.• Select parameter Ec.1 and adjust increments per revolution• Select Ec.42 (Ec.20 upto V2.8) and adjust the encoder breakage recognitiondependent on the case of operation.5. Error MessagesError messages and their meaning are described in Chapter 9 of the application manual.

/ 24

Related manuals for KEB COMBIVERT F5