KEDDY K700 Installation Instructions Manual
Also see for K700: Installation instructions care and firing instructions
            | |
- 7 -INSTALLATION INSTRUCTIONSBefore starting on the installation of the stove, the following steps need to be fully completed:The chimney:Alternative 1 An existing chimney prepared for rear connectionAlternative 2 A newly installed chimney prepared for rear connectionAlternative 3 Preparation for a new top connection chimneyOutdoor air supply (if so required)Hearth floor plate (unless a floor plate or floor glass is to be installed afterwards)1. Move the stove indoors and put it intoposition. Adjust the stove horizontally andvertically using the feet under the base by thefloor.A suitable place to check horizontally andvertically with the help of a spirit level is onthe hearth's sealing plate.Tip! The stove is vertical and horizontalwhen the door stays open at an opening an-gle greater than 90-95 degrees and when itcloses automatically at an opening angle lessthan 85-90 degrees.Where applicable, connect outdoor air to thehearth.2. To dismantle the front/door, start byunscrewing the two front bolts that securethe inner roof to the cassette front. After this,loosen the centre screw at the centre of theinner roof's front edge.Then open the door fully. Unscrew the fourbolts in each corner.After this, carefully pull the front towards youuntil it comes free from the two guide rails.Carefully put the front to one side, to avoiddamage to the opening handle. The front anddoor weigh approx. 35 kg. |
Related manuals for KEDDY K700
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine