KENT RAZOR 17B Instructions For Use Manual
                                                                    | |
INSTRUCTION MANUAL FOR USE AND MAINTENANCE08812946(3)2003-08 11AFTER MACHINE USEAt the end of the work, before leaving the machine:1. Disconnect the brush in the following way:the brush lifted, push the brush switch (5, Fig. B)to on position "I"; after a few seconds, put theswitch back to off position "0", releasing the brush.2. Empty the tanks (5 and 6, Fig. H), following theinstructions in the previous paragraph.3. Perform the maintenance operations after themachine use (see chapter "Maintenance").4. Leave the machine in a dry and clean place, withbrush and squeegee lifted or removed.MACHINE LONG INACTIVITYIf you foresee that the machine will not be used formore than 30 days, proceed as follows:1. Perform the operations described in the previouschapter "After Machine Use".2. Disconnect the battery connector (25, Fig. C).3. Disconnect the positive battery terminal (+)directly from the battery (+) pole.FIRST PERIOD OF USEAfter the first period of use (first 8 hours) it is necessaryto check that the fixing and connecting elements arecorrectly fixed, that the visible parts are integral andthat there are no leaks.MAINTENANCEThe machine proper and safe operation is guaranteedby a careful and constant maintenance.The following table sums up the scheduled maintenan-ce. The indicated periods can be subjected to varia-tions according to working conditions. These must bedefined by the person in charge for the maintenance.All periodic or extraordinary maintenance operationsmust be performed by skilled personnel, or by an autho-rized Service Center.This Manual contains the Scheduled Maintenance Ta-ble and describes only the easiest and most commonmaintenance procedures.WARNING!The operations must be carried out withthe machine off and the battery discon-nected.Moreover, read carefully the instruc-tions in the Safety chapter before per-forming any maintenance operation.REMARK:For other maintenance procedures con-tained in the Scheduled MaintenanceTable see the specific “Service Manual”that can be consulted at the Kent/Euro-clean Service Center.SCHEDULED MAINTENANCE TABLE(1): and after the first 8 working hours(2): contact the Kent/Euroclean Service Center for these maintenance operations(*): 20BT versions onlyOperation Daily, aftermachine use Weekly Every sixmonths YearlySqueegee cleaning "Squeegee blade check (and replacement) "Brush cleaning "Tank and suction grid with float cleaning "Detergent filter cleaning "Battery charge "Lead battery (WET) liquid level check "Nut and screw tightening check " (1)Brush electric motor carbon brush check or replacement " (2)Suction electric motor carbon brush check or replacement " (2)Drive motor brush (or carbon brush) check or replacement (*) " (2)Grease drive shaft bearings (*) "https://harrissupplyind.com - To Order Parts Call 608-268-8080 |
Related manuals for KENT 908 7010 020
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine