KENT SelectGloss KF-2019B Owner's Manual

Contents

5PRODUCT IDENTIFICATIONIf service is required, contact the dealer from whichthe machine was purchased or an authorized servicestation. The model and serial number are on the ratingplate, please write them in below. For prompt and accu-rate information, refer to these numbers when inquiringabout service. Always refer to your limited warranty forcomplete service information.MODEL# SERIAL#OPTIONAL ACCESSORIESFor a complete list of all available accessories and or-dering information, contact your local equipment dealeror the dealer from which the machine was purchased.SOLUTION1. Check batteries and charge or replace.2. Adjust speed control knob as needed.1. Check batteries and charge or replace.2. Reset by pushing circuit breaker button.3. Adjust pad pressure knob accordingly.4. Move control handles to either forward orreverse position.1. Raise the pad head and clean the pad.2. Replace the pad.1. Recharge batteries fully before beginningoperation.2. Clean thoroughly.3. Replace defective battery.1. Check pad and replace if worn ordamaged.2. Reinstall pad, make sure it is centered onthe padholder.1. Reset by pushing circuit breaker button.2. Reduce pad pressure using adjustmentknob.3. Raise the pad head and clean the pad.4. Contact the dealer from which themachine was purchased, or an autho-rized service center.1. Contact the dealer from which themachine was purchased, or an autho-rized service center.CAUSE1. Battery condition low.2. Speed set too low.1. Battery condition low.2. Circuit breaker tripped.3. Pad pressure adjustment knob set tohighest or lowest setting possible.4. Control handles not in operating position.1. Debris lodged under pad.2. Worn pad.1. Battery charge condition very low.2. Corroded wires or connectors.3. Bad Battery.1. Pad worn or damaged.2. Pad not installed correctly.1. Momentary motor overload.2. Too much pad pressure.3. Possible lodged debris.4. Damaged motor.1. Short circuit in dynamic braking circuit.PROBLEMMachine will not movePad drive motor will not startMachine streaking a cleaned floorShort operating timeHigh vibration70 AMP breaker trips or trips repeatedly5 AMP breaker tripsTROUBLE SHOOTING GUIDEhttps://harrissupplyind.com - To Order Parts Call 608-268-8080