KERN 572-30 Operating Instructions Manual

Also see for 572: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Contents

KERN 572-30 Operating Instructions Manual Manual pdf 32 page image

572/573/KB/DS/FKB/FCB/PCB-BA-e-0957327.3 Display background illuminationAfter having switched on your balance and the zero display, press the „MODE“ button to select the menupoint „Backlight“. Acknowledge by pressing the „YES“ button in order to switch on the permanent back-ground illumination. By pressing the „NO“ button, the background illumination is switched off.If the background illumination shall be switched off time-controlled (to save the battery), press the „MODE“button to select the menu point „Backlight auto“ and confirm by pressing the „YES“ button. The backgroundillumination will be switched off automatically 10 sec after having reached a stable weighing value.7.4 Interface RS 232 CTechnical Data 8-bit ASCII Code 1 start bit, 8 data bits, 1 stop bits, no parity bit Baud rate adjustable to 2400, 4800 and 9600 baud (default), 19200 baud Sup-D- 9 pol. is necessary . When working with an interface correct operation is secured only if the corresponding KERN-interface-cable (max. 2m) is used.Description of the jackSup-D- 9 pol.5 19 6Pin 2: Transmit dataPin 3: Receive dataPin 5: Signal groundBaudrateThe Baud rate for the data transfer is adjusted with the MODE-key. The following example demonstrateshow to set the Baud rate 4800.Select Baud rate Display1. Press MODE-key repeatedly until "PRINTER" is displayed.2. Press YES-key.3. Press MODE-key repeatedly until the desired Baud rate appears (forinstance 4800 Baud).4. Press YES-key to select 4800 Baud. The tick-mark (X) confirms the newsetting.5. Press MODE-key repeatedly until the balance displays in grams again,or press tare key.PRINTER?2400 Baud4800 Baud4800 Baud X0,0 g