KERN CKE 360-3 Operating Manual

Also see for CDS 100K0.5: Operator's manual

Contents

KERN CKE 360-3 Operating Manual Manual pdf 18 page image

7.3 Data output RS 232 CTechnical Data8-bit ASCII Code 1 start bit, 8 data bits, 1 stop bit, no parity bit Baud rate selectable from 2400, 4800, 9600 Baud (factory setting) and 19200 Baud. Sub-D plug 9-channel required For operation with interface faultless operation is only ensured with the correct KERN – interface cable(max. 2m)Pin allocation of the balance output socket (front view)Sub-D jack 9-channel5 19 6Pin 2: Transmit dataPin 3: Receive dataPin 5: Signal groundBaud rateThe MODE key is used to set the Baud rate used for the transfer of measured values. In the following examplethe baud rate is set to 4800 baud.Setting Baud rate KERN CKE Display1. Switch on balance2. Press and hold tare key3. Tap ON/OFF key and let go of tare key"Cal?" will appear on the display.4. Keep holding the switch over key „pcs ↔ g“ until "Printer" appears on thedisplay and confirm by pressing the "20x" key. 2.400 Bd will appear on thedisplay.5. Press the switchover key "pcs ↔ g" to select the Baud rate and confirmby the “20x” key. To return to weighing mode, press the tare key.PRINTER?2400Baud4800Baud4800 Baud X0.00 ozCKE/CDS-BA-e-152618