KERN CKE 6k0.02 Operating Manual

Also see for CKE 16k0.05: Operating manual Operator's manual Operating manual User manual Operating instructions

Contents

CKE-BA-e-0913167.4 Interface RS 232CData output via interface RS 232CGeneral InformationThe previous condition for the data transfer between balance and a peripherical device (e.g. printer, PC ...) isthat the appliances are set to the same interface parameters (e.g. baud rate, parity ...).7.4.1 There are 4 kinds of data output via RS 232CData output using the PRINT keyThe printing process can be triggered by pressing the PRINT key.The settings AUTOPRINT and AUTOPRINT PC should be disabled for this process.AUTOPRINT (data output according to weight application)The setting AUTOPRINT is located on the PRINTER path where you can turn it on or off. When AUTOPRINTis active, the current weighing value will be sent via the RS 232 date interface after unloading and subsequentloading of the balance as soon as the balance is in resting position.AUTOPRINT PC (continuous data output)The setting AUTOPRINT PC is located on the PRINTER path and where you can turn it on or off. WhenAUTOPRINT PC is active, the current weighing values will be sent continuously via the RS 232 data interface.Data output and remote control commandsRemote control commands transferred as ASCII characters to the balance can be used to trigger the followingfunctions on the balance (always finish with CR, LF!):t Taringw The balance sends a weighing value (also unstable) via the serial interface.s The balance sends a stable weighing value via the serial interface.After receiving either character w or s, the balance will send without a printer pause between the characters.7.4.2 Explanation of the data transferEach data transfer is structured as follows:Without numeratorBit no. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18B B B B B B B B 0 . 0 B g B B CR LFB*B : = Blank or for ? autotare on in zero range.B, 0, ., g: = Blank or weighing value giving unit according to loading of the balanceCR: = Carriage ReturnLF: = Line FeedWith numerator:Bit no. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20N N N B* B B B B B B B 0 . 0 B G B B CR LFN: = Numerator7.4.3 NumeratorThe numerator is situated under the menu item "Printer" where it can be activated or deactivated.When data output takes places via the printer key, it will be increased by one digit per key stroke.

/ 19

Related manuals for KERN CKE 16k0.05