KERN CPB 3K1M Service Manual

Also see for CPB 15K0.5: Operating manual Operating manual

Contents

4.1.1 F1 - CALIBRATIONTo enter the calibration parameter, press the [Tare] key when “F1” “CAL” is displayed.The Weight display will instruct you to remove any weight from the scale, “UnloAd”Press the [Tare] key. The displays will ask you to place the calibration weight on thescale: “LoAd” “06” “kilo6”NOTE: The CPB-M series should be calibrated with the full capacity weight. That is forCPB 6K2M, use 6 kg as calibration weight.Add the suggested calibration weight as displayed or press the key to clear thevalue and enter another value of weight. To add this value to the platform, wait forstability then press the [Tare] key.The display will show “SPAn” “PASS” if the calibration is OK. Or it will show “SPAn” “FAIL”if calibration could not be completed correctly.The display will show “JP On”. Remove the calibration mass.Remove the jumper and the scale will run a self-test and return to normal operation.4.1.2 F2 - PIN FOR CALIBRATIONThis parameter allows changing of the PIN number to gain access to calibration.To set the PIN, press the [Tare] key when “F2” “Pin” is displayed.The display will show “Pin 1”Enter the new Pin number. Press the [Tare] key to accept.The display will show “Pin 2”Enter the new Pin number a second time. Press the [Tare] key to accept.CPB-SH-e-0721 9