KERN EMB 100-3 Operating Instructions Manual

Also see for EMB: Service manual Operating instructions Operating instructions

Contents

KERN EMB 100-3 Operating Instructions Manual Manual pdf 9 page image

5.2 UnpackingCarefully remove the balance from its packaging, remove the plastic wrapping andposition the balance in its intended working location.5.2.1 InstallationInstall the balance in such a fashion that the weighing plate is absolutely horizonta5.2.2 List of items suppliedStandard accessories:KERN EMB• Balance• Operating manual• Batteries (2 x 1,5 V) or 1 x 9 V5.3 Battery OperationRemove the battery cover from the bottom of the balance. Connect 2 x 1,5V or 1 x 9Vbatteries (EMB 200-2/EMB600-2 Block-Battery 9 V). Re-insert the battery cover.Battery conservation through automatic power-off 3 minutes after ending a weighingoperation.When the battery power is used up the display will show “LO“. Press the key andchange the batteries at once.When the balance is not in use for a longer period of time remove batteries and keepthem separately. Leakage of battery liquid might damage the balance.5.4 Mains supplyElectric power supply is by means of the external mains supply circuit. The printedvoltage level must comply with the local voltage.Only use original KERN mains supply circuits. The use of other makes is subject toapproval by Kern.5.5 Initial start-upA warm-up time of 3 minutes stabilises the measured values after switching on.The accuracy of the balance depends on the local acceleration of the fall.Please be sure to observe the information in the chapter on adjusting.EMB-BA-e-1132 9