KERN EW - 300 - 2M Service Manual
                          | |
Contents
| 
EW/EG-KB-e-9811 154.3 How to adjust overload stopper1. Apply the pan base on the mechanism.Then slide out stoppers by loosening two fixing screws with a hexagon wrench of 3 x 3.2. Press the ON/OFF key to on while pressing F key and T key togetherRelease both keys when DJr____ appears.3. Apply reference weights up to the Stopper Setting Value specified in thetable in page 15*1.Press the T key to clear the display to zero (0).4. Insert stoppers until they slightly touch corresponding guide link.Holding the stopper with a screw driveror the like, fix the stopper by drivingthe cap screw securely.5. The adjustment is good if display showsbetween -5g and -50g.Even the display shows "0", if the guidelink touches (stopped by) stoppers by increasing reference weights up toMaximum specified in the table 15*2, the adjustments is good.HOW TO KNOW WHEN LINK TOUCHES STOPPERWhile increasing weights, when the guide link touches the stopper, thedisplay will not show as much value as increased weight.This indicates the guide link has touched the stopper.6. How to correct the settingIf the display value in above 5. Is less than -50g, such as -100g forexample, slide out stoppers a little from the guide link.If the display value in above 5. Is over -5g, such as +5g for example,insert the stoppers slightly more into the guide link. |
Related manuals for KERN EW - 300 - 2M
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine