IFB-BA-e-1012126 Unpacking and implantation6.1 Installation Site, Location of UseThe balances are designed in a way that reliable weighing results are achieved incommon conditions of use.You will work accurately and fast, if you select the right location for your balance.On the installation site observe the following:• Place the balance on a firm, level surface;• Avoid extreme heat as well as temperature fluctuation caused by installingnext to a radiator or in the direct sunlight;• Protect the balance against direct draughts due to open windows and doors;• Avoid jarring during weighing;• Protect the balance against high humidity, vapors and dust;• Do not expose the balance to strong humidity for extended periods. Non-permitted condensation (condensation of air humidity on the appliance) mayoccur if a cold appliance is taken to a considerably warmer environment. Inthis case, acclimatize the disconnected appliance for ca. 2 hours at roomtemperature.• Avoid static charge of goods to be weighed or weighing container.• Being of protection type IP 67 as per DIN EN 60529, the weighing scale issuitable for short-term use in wet conditions.Major display deviations (incorrect weighing results) may be experienced shouldelectromagnetic fields (e.g. due to mobile phones or radio equipment), staticelectricity accumulations or instable power supply occur. Change location or removesource of interference.6.2 Unpacking/implantationTake the balance carefully out of the package, remove the plastic cover andplace it in the designated work area.Scope of delivery / serial accessories:• Balance, see chpt. 2• Mains power supply• Operating instructions