KERN PKS 200-3 Operating Instructions Manual

KERN PKS 200-3 Operating Instructions Manual Manual pdf 27 page image

PKP_PKS-BA-e-1313 278.2.1 There are 4 kinds of data output via RS 232CData output using the PRINT keyThe printing process can be triggered by pressing the PRINT key.The settings AUTOPRINT and AUTOPRINT should be disabled for this process.AUTOPRINT (data output according to weight application)The setting AUTOPRINT is located on the menu item “Data transfer G10“ for basic settingswhere you can turn it on or off. When AUTOPRINT is active, the current weighing value willbe sent via the RS 232 date interface after unloading and subsequent loading of thebalance as soon as the balance is in resting position.Permanent PRINT (continuous data output)The setting Permanent Print is located on the menu item “Data transfer G10“ for basicsettings where you can turn it on or off. When Permanent Print is active, the currentweighing values will be sent continuously via the RS 232 data interface.Data output and remote control commandsThe setting Remote Control Command is located on the menu item “Data transfer G10“ forbasic settings where you can turn it on or off.Remote control commands transferred as ASCII characters to the balance can be used totrigger the following functions on the balance (always finish with CR, LF!):t Taringw The balance sends a weighing value (also unstable) via the serial interface.s The balance sends a stable weighing value via the serial interface.After receiving either character w or s, the balance will send without a printer pausebetween the characters.8.2.2 Explanation of the data transferEach data transfer is structured as follows:Bit.Nr. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20N N N N N B B B B B B B B B B B 0 • 0 0Bit.Nr. 21 22 23 24 25 26E E E E CR LFN = NumeratorB*: = Blank or for autotare on in zero range.B, 0, ., g: = Blank or weighing value giving unit according to loading of the balanceE = UnitCR: = Carriage ReturnLF: = Line Feed