KERN VHP-T Operating And Installation Instructions

KERN VHP-T Operating And Installation Instructions Manual pdf 12 page image

12 VHP-T-BA_IA-e-16117.6 Selection of platform quantity1. Turn on device using the - - button2. Use button to change into the window for dateinput.3. Now enter the following password: 878586 (the last twociphers can be ignored)4. Use the C button to change between the individualparameters.5. Select the parameter (8): Mode6. Confirm by pressing the button7. Now enter the quantity of platforms. As per standardthere are 2. (up to 6 platforms available)7.7 AdjustmentAs the acceleration value due to gravity is not the same at every location on earth,each display unit with connected weighing plate must be coordinated - in compliancewith the underlying physical weighing principle - to the existing acceleration due togravity at its place of location (only if the weighing system has not already beenadjusted to the location in the factory). This adjustment process must be carried outfor the first commissioning, after each change of location as well as in case offluctuating environment temperature. To receive accurate measuring values it is alsorecommended to adjust the display unit periodically in weighing operation.• Prepare the required adjustment weight. The weight to be used dependson the capacity of the scale. Carry out adjustment as near as possible tothe scale’s maximum weight. Info about test weights can be found onthe Internet at: http://www.kern-sohn.com.• Observe stable environmental conditions. Stabilisation requires a certainwarm-up time.