Kaba 7102 series Installation Instructions Manual

Also see for 7102 series: Installation instructions

Contents

Kaba 7102 series Installation Instructions Manual Manual pdf 7 page image

5-1.4-1.74A B55-2.Making the Bolt FacePlate CutoutInstalling the BoltRIGHT HAND DOOR(see template)1) Insert the bolt, with the arrow pointingup, into the 1" (25 mm) hole, figure 5-1.2) Secure the bolt face plate to thedoor with the two Phillips-headscrews provided.LEFT HAND DOOR(see template)1) Insert the bolt, with the arrowpointing down, into the 1" (25 mm)hole , figure 5-2.2) Secure the bolt face plate to the door withthe two Phillips-head screws provided(pg.7, H).This procedure is applicable to wood doors.1) Insert the bolt into the 1" (25 mm) holeuntil the face plate butts up against thedoor edge. Draw a line around the faceplate. Remove the bolt from the door,figure 4-1, A.2) For doors without a beveled edge, use asharp 1" (25 mm) wood chisel to removeapproximately 1⁄8" (3 mm) of material orenough so the face plate is perfectly flushwith the edge of the door, figure 4-1, B.3) For doors with a beveled edge, followStep 2 except the face plate will not beflush with the edge of the door, but rathersquare to the face of the door. In order toaccomplish this, you must remove morewood from the higher edge of the door.