Kaba E-PLEX 2000 Series Installation Instructions Manual

Also see for E-PLEX 2000: Operation manual Operation manual Installation instructions Quick reference guide

Contents

Kaba E-PLEX 2000 Series Installation Instructions Manual Manual pdf 39 page image

37F. INSTALLING OPTIONAL K-I-L KEY OR BESTREMOVABLE CORE OVERRIDE AND OUTSIDE LEVERImportant: Assemble the lever, cylinder and lock components before affixingthe entire unit to the door.F-1 Upon unpacking, the lock housing with mechanicaloverride should look like the diagram below with:• The small indents (i) on the cross of theoverride shaft (m) in line horizontally• The plastic washer (c) on the drive tube• The lever catch (f) in the out position• Cylinder (j) and 2 keys (n) (included in thehardware bag)• Shaft override tool (o) (included in thehardware bag)F-2 Using the override shaft tool (o), turn the overrideshaft clockwise until it stops so that the two smallindents on the cross are now vertically in line.F-3 Push in the lever catch (f) firmly.F-4 Insert the cylinder (j) into the lever handle (h).Note: For Best Removable Core, use Steps F-5,F-6 and F-7, then proceed to F-10 and continue.For Optional K-I-L Key, skip ahead to F-8 andproceed as normal.For Best Removable CoreF-5 Insert 6-pin Best adapter (thicker) into6-pin interchangeable core or insert7-pin Best adapter (thinner) into 7-pin interchangeable core. Insert theadapter until it makes contact withthe removable core.F-6 Using the control key, assemble theremovable core with its adapter intothe lever. Remove control key.F-7 Insert the change key into the removablecore.f7-pinadapterThinneradapterThicker6-pin(j)(o)hj(f)(i)(m)(c, d) (n)