Kaba E-PLEX 5x70 Series Installation Instructions Manual

Contents

Kaba E-PLEX 5x70 Series Installation Instructions Manual Manual pdf 5 page image

5A-2. GANG BOX INSTALLATIONA-2.1 Mount Gang Box on the wall referring to the Template toinsure clearance above the box. This allows the KeypadHousing to be moved up, then in and down onto the Baseplate.Mark and drill holes for wood screws, wall anchors, or masonryscrews and a 1⁄2" diameter cable hole.A-2.2 Thread the cable from the back of the Outside Housingthrough the large hole in the Shim, into the hole in the GangBox and into the wall. Remove the two security screws fromthe bottom of the Backplate & Gasket using the small wrenchprovided in the bag. Slide the back down about one inch whilepushing it away from the housing.A-2.3 Position the Backplate & Gasket, sandwiching the Shim againstthe Gang Box and fasten the Backplate & Gasket with #6 FlatHead screws into the two smaller holes that line up with theholes in the Gang Box.A-2.4 Push all excess cable into the wall conduit. Hold the top of theOutside Housing about one inch above the top of the Base-plate that is now screwed to the Gang Box and push until theGasket is flush with the back edges of the Outside Housing.Now push in and down until the bottom of the Baseplate andthe bottom of the Outside Housing are flush. Use the wrenchprovided to replace the security screws.GANG BOX SHIM BACKPLATE& GASKETOUTSIDE HOUSINGWITH KEYPADSECURITYSCREWS