Kaba E-Plex 5900 User Manual

Also see for E-Plex 5900: Installation

Contents

Kaba E-Plex 5900 User Manual Manual pdf 20 page image

20/372016. Quick lock configurationThe following tables describe the sequence of commands required to configure the lock from factory,construction and access mode. Note that:o Typically a timeout of 5 seconds applies to key presses and card detection. After this delay, thecurrent operation is cancelled (red led turns on along with low pitch sound).o Keypad commands are always followed by a ‘#’ key.16.1 In Factory or Construction modeStep Sub Description/Operation Notes1 Reset the lock to factory mode1 Insert and turn mechanical key in keycylinder to retract latch and holdNote: Resetting the lock to factory defaultscan be done while in any mode -> factory,construction or access.2 Press and release ‘#’ key on lock keypad3 Release mechanical key Once done, red and green led leds blink inalternate sequence4 Enter reset command:o 12345678#Once done, green led blinks with high pitchsound indicating successful operation2 Enter lock keypad programming. Programming mode is entered by pressingthe ‘#’ key followed by the default PIN andthen pressing ‘#’ again. Any command willexit back to keypad programming mode ifthe lock is idle for 5 seconds. The keypadprogramming mode is itself exited when nokey is pressed for 5 seconds.1 Enter keypad programming mode bytyping:o #12345678#Green led and high pitch sound on success.3 Change default (factory mode) PIN Must change default pin to enterconstruction mode.1 Enter the change PIN command:o 000#2 Enter the new (construction mode) PIN:o XXXXXXXX#The construction PIN is always 8 digits.3 Enter the new PIN AGAIN:o XXXXXXXX#Once entered, the green led turns on with ahigh pitch on success.4 Prepare the maintenance unit (M-Unit)1 Start the E-Plex 5900 M-Unit applicationon the PDA2 Select ‘Comm key’ option3 Enter the communication key (16 zerosby default) and select ‘ok’Upon factory reset, the communication keyis set to 16 zeros.4 Select the ‘Set Time’ option and set thedate/time related parameters.Important: It is extremely important that thedate/time be set correctly. The date, timeand time zone must be set properly becausethe card-connected credentials rely on them.Once in access mode, invalid time settings