Kalamera KRC-40DZB Instruction Manual
          | |
- 9 -between 5~18°C or 1°F between 40~66°F. To turn on or off the internal LED lighting, press LIGHT button on the right side. To switch the temperature display from Celsius Degree to be Fahrenheit Degree or vice versa, press LIGHTbutton for 3 seconds. To shut down inner light and control panel display light (button and display light), please press and hold both UP& DOWN buttons for 3 seconds. The cooler will keep running normally. Re-press and hold both UP & DOWNbuttons for 3 seconds, the cooler will be restore to its normal status, with inner light and control panel light on. When door is not closed within one minute after opening or is not properly closed, LED display will gleam andcooler will beep as alarm. The alarm will stop when door is closed or any button is pressed.Care And MaintenanceCleaning your wine cooler Unplug the wine cooler and remove the bottles. Wash the inside with warm water or baking soda solution. The solution should be about 2 tablespoons of bakingsoda to a quart of water. The outside of wine cooler should be cleaned with mild detergent or warm water. Draw out the water box at the bottom, and wash it.Moving your wine cooler Remove all the bottles. Securely tape down all loose items inside your wine cooler. Turn the leveling legs up to the base to avoid damage. Tape the door. Be sure the wine cooler stays in the upright position during transportation.Trouble ShootingsYou can solve many common wine cooler problems easily, saving you the cost of a possible service call. Try thesuggestion below to see if you can solve the problem before calling the service center.PROBLEM POSSIBLE CAUSEWine cooler do not operate. Not plugged in using different voltage. The circuitbreaker tripped or a blown fuse.Wine cooler is not cold enough. Check the temperature control setting.The door is open too often.The door is not closed completely.The door seal does not seal properly.The wine cooler does not have the correctclearance.The light does not work. Main control board does not work.PCB Problem.There is some problem with the plug.Vibrations. Check to assure that the wine cooler is leveled.The wine cooler seems to make toomuch noiseThe wine cooler is not leveled.Check the fan.The door will not close properly. The wine cooler is not leveled.The doors were reversed and not properly installed.The seal is weak. |
manualsdatabase
Your AI-powered manual search engine