Operating Instructions K&F SONA 8KLING & FREITAG GMBH © 2016 Version 1.4 Page 12 of 215. Make sure that the stand pole inthe stand adapter reaches up tobehind the clamp screw.Tighten the clamping screw.The speaker is now securelyconnected to the stand. Now adjustthe speaker.6. Proper Alignment of the LoudspeakersPlease note that precisely targeted speaker systems can significantly improve the acousticresult. It is not possible to make generalities about the alignment of specific systems becausethe room has a substantial influence on the signal and the audible result.As a rule, the mid- and high-transducers of loudspeakers should be mounted above theaudience's face value, so that the sound distribution cannot be shadowed.In many cases it is advisable to mount a loudspeaker higher, so that the sound will bedistributed throughout the room more evenly. Low standing systems result in a greaterdifference in volume between front and back seats than higher standing systems.To simulate the correct alignment of the speakers beforehand, there are various programssuch as ‘EASE’ or ‘Ulysses’. On the homepage www.kling-freitag.de, KLING & FREITAGprovides the simulation data for the speakers to be downloaded.7. WiringWarningSpeaker-signal currents are potentially hazardous to the human body.When the system is in use, make sure that the connectors are secured against inadvertenttouch.Always fully insert bared wire ends into the push connector or the Phoenix plug such thatbared parts of wire can not be touched.For speakers with Phoenix connector the bared wire ends have to be accurately screwed intothe plugs.7.1 Terminal assignmentSpeakOn connector Phoenix connector-1-2-1+2++IN1 1 1 1Pin 1 is parallel at all connections.7.2 Wiring DiagramsYou will find all necessary pin diagrams for operations with the CD 44 Controller inthe operating instructions of the CD 44! This applies for use with and without the K&FSubwoofer.