6SAFETY INSTRUCTIONS - IMPORTANT NOTESSafety during installation workWhen carrying out installation work in locations where there is a risk of falling, take appropriatesafety precautions, e.g. use of a working platform. Make sure that the vehicle roof issufficiently strong and stable to carry out the installation work (risk of damage or collapsingof roof).In case of doubt, contact a qualified specialist dealer or the manufacturer of your vehicle tofind an appropriate installation location.Make sure that:- The turntable and connected units are disconnected from the power supply- The person carrying out the installation or repair does not suffer from vertigo and can move aroundsafely on the roof of the caravan or motor home- The person carrying out the installation or repair is wearing sturdy and non-slip shoes- The person carrying out the installation or repair has a secure position to stand and hold on whileworking- The roof and the climbing equipment used (e.g. ladder) are dry, clean and non-slip- The roof can withstand the weight of the person carrying out the repairsAttention! Risk of death or injury due to falling or the roof collapsing!- Nobody should be inside the caravan/motor home underneath the antenna during dismantling/installationAttention! Risk of death or injury due to possible roof collapsing and falling parts!Proper installation and safetyEssential informationA crucial safety factor is proper performance of installation and electrical connection work, and thespecified alignment of the turntable in the direction of travel (park position), see also installation andconnection.Comply as precisely as possible with the installation conditions and steps described.Modifications to the electrical installations in the vehicle should only be carried out by a specialist invehicle electrics. Do not make any unauthorised changes to the turntable.Adhesive sealantThe turntable is attached to the roof of the vehicle by adhesive and is secured by additional screws.Note that the curing of the adhesive sealant is temperature-dependent. It reaches its full strength onlyafter approximately five days.During installation work, comply strictly with the processing and safety instructionsfor the adhesive sealant (Sikafl ex ® 291 safety data sheet and Sikaflex ® 291 technicaldata sheet).