Kathrein RRU4-RS4-E6 Installation Manual
Also see for 52010093: Configuration manual
                                        | |
Contents
| 
Installation manual Reader 31Modifications, misprints and errors exceptedEnglish4. Connections and displays4.12. Antenna Connection4.13. LED4.14. BuzzerFor the connection to the RFID antennas, the reader has four antenna connections that are of reverseTNC design. Please only use the cable from the accessories or equivalent cable for this connection.NotePlease only use cable suitable for the impedance (50 Ohm), as otherwise the performance of the reader will beseverely limited by the mismatch. If the mismatch is large, the reader may indicate a fault.The reader has a 2-colour LED for the indication of the operating state. The table below shows the colours usedand the related operating state.Red Green Operating stateX flashes approx. every 8 seconds Error during initialisationX X Unit is bootingFlashes approx. every 8 seconds X Normal operation with heartbeatThe reader has also ARU4 the antenna dome 4 LEDs. (Red / green / red / green) that can be controlled via softwareTable: Indication of the operating states by the LEDFurthermore the reader is also fitted with a buzzer which, in addition to the LED, indicates successful booting(1 x short) or an error (2 x long). |
Related manuals for Kathrein 52010093
This manual is suitable for:
520100935201009452010095520100965201009752010099520101005201010152010102520101035201010452010135520101365201017152010180520101815201019052010191520101985201019952010200520102015201022552010226ARU4-ELC-U6ARU4-ELK-E6ARU4-ELK-U6ARU4-ETG-E6ARU4-ETG-U6ARU4-ETL-E6ARU4-ETL-U6ARU4-RS4-E6ARU4-RS4-U6ERU-ETG-E4ERU4-ETG-U4M-ARU-ETH-E6M-ARU-ETH-U6M-ARU-RS232 ETSIM-ARU-RS232 FCCRDR-ETH-E4RDR-ETH-U4RRU4-ELC-E6 KRAIRRU4-ELC-U6 KRAIRRU4-ETG-E6RRU4-ETG-U6RRU4-ETL-E6RRU4-RS4-E6RRU4-RS4-U6
manualsdatabase
Your AI-powered manual search engine