In our presets, the Vertical Slider banks are all controlled using the nearest Up/DownButton pair. The Long Slider banks are controlled using the Up/Down Button pair onthe right side of the Long Slider. The images below show how the Vertical and Long Sliderbanks are indicated with the Up/Down Button LEDs:Bank 1 - no LEDs Bank 2 - top LED only Bank 3 - bottom LED only Bank 4 - both LEDsIn our presets, the Rotary banks are both controlled using the Rhombus Button. Theimages below show how the Rotary banks are indicated with the Rhombus Button LEDs:Bank 1 - no LEDs Bank 2 - only thegreen LED is onBank 3 - both red and greenare on to make orangeBank 4 - only thered LED is onUsing the QuNeo Editor, the bank controls for the Vertical Sliders, the Long Slider, andthe Rotaries can be chosen. Both Up/Down Button Pairs and the Rhombus Button can beassigned to one of these sensors if editing presets in the Editor. See the QuNeo Editorchapter for more information about editing presets.The Mode ButtonThe Mode button is a small circular button that can be found in the upper left corner of theQuNeo. When illuminated, the button is blue. The Mode button serves as the gateway toselecting presets and entering CoMA mode (our Controller Mapping Assistant).Selecting PresetsAfter plugging in the QuNeo, it will automatically load the last preset you used. The firsttime, it will load Preset 1.To enter preset mode, quickly tap the Mode button so that it begins to flash blue.After entering Preset mode, the pad for the current presetwill be illuminated in red. Select a preset by pressing oneof the pads. The selected pad will briefly blink green andQuNeo will exit Preset mode and go to the selected preset.The image to the left shows how the pads are numberedand which pad to select for which preset number.Tapping the Mode button again will put QuNeo back intoPreset mode at any time.For detailed information about the factory presets, see the Factory Preset Guides chapter ofthis manual.9