Kelvinator KGC20BN Series User Manual
                | |
Kelvinator gas continuous flow hot water system initial operation 7Initial operation4. Turn on the 240 volt 50 Hz power supply to thewater heater.5. Open a hot water tap or fixture and verify that hot water isnow available.cautionThe following process should be completed by theinstaller only.Once all checks have been completed, please clean filter ofany debris. Refer to page 10 for instructions.1. Fully open the manual water control valve on the watersupply line.2. Open a hot water tap to verify that water is flowing tothat tap then turn the tap off.3. Fully open the manual gas control valve installed andcheck for leaks.warningIf you smell gas or a gas leak is detected after opening themanual gas control valve, immediately close the valve. Donot turn on power to the water heater and keep potentialignition sources away. Call a service technician to inspectand repair the leak. |
Related manuals for Kelvinator KGC20BL Series
manualsdatabase
Your AI-powered manual search engine