Kemppi FastMig KM 300 Operating Manual

Also see for FastMig KM300: Operating manual Service manual Operating manual Operating manual

Contents

Kemppi FastMig KM 300 Operating Manual Manual pdf 9 page image

EN3. MACHINE USE3.1 Starting of the power sourceStart the power source by turning the main switch (A2) on the front panel to the ‘I’ position.The standby indicator (A3) turns on. The control panel and wire feeder are not operational yet,and the text ‘OFF’ is shown on the control panel display.NOTE! Always turn the device on and off using the main switch, not via the mains socket.The cooling fan is started for a moment when the main switch is turned to the ‘I’ position. Thefan turns off after a while and then restarts during welding when the machine has warmed upsufficiently. The fan continues running even after up to 10 minutes of welding, depending onthe temperature of the machine.3.2 Front panel indicatorsThe following indicators can be found on the front panel of the device:• When the green indicator, A3, is on, the power source is in standby mode. This indicatoris on when the machine is connected to the mains supply with the main switch in the ‘I’position.• When the yellow overheating indicator (A4) is on, the machine has overheated. The fanthen starts. When the indicator turns off, the machine can be used again.• When indicator A4 blinks, the machine has experienced a failure. Attempt to remedy theproblem according to the instructions in Section 4, ‘Troubleshooting’. If the failure cannotbe eliminated, turn off the machine, and turn it on again. If the failure persists, writedown any fault code that may be shown on the display and contact authorised Kemppiservice agent.GAS TESTDYNAMICS WIRE INCHwelddataVAm/min4TSETUP2TKM W001319LOCALREMOTEP1 P2P9P7P3 P4 P5P10P6P87© Kemppi Oy / 1152