Kemppi KM 300 Service Manual

Also see for FastMig KM300: Operating manual Operating manual Operating manual Operating manual

Kemppi KM 300 Service Manual Manual pdf 29 page image

Wire feed speed calibration / KM• In factory set Wfs is adjusted in the range of 4...100 without any unit• LED light and feed roll symbol tells that the parameter to be set is Wfs• After Wfs Calibration m/min unit is displayed• Drive filler wire through the MIG gun and contact tip• Enter to User Setup Menu by pressing SETUP button ( appr 5 s )• Select the Calibration menu ( CAL ) with left side potentiometer• Select "Enter" ( Ent ) with right side potentiometer• Approve your selection by pressing briefly REMOTE / LOCAL key• Select 'm/min' as calibration value of the quantity with right side potentiometer• Approve selection by pressing briefly REMOTE / LOCAL key• Set first Calibration point (e.g. 2.0 m/min ) with left side potentiometer1. Press MIG gun trigger and let the wire run until it stops automatically2. Measure the length of feeded wire with the accuracy of 1 cm3. Enter wire length to the panel display ( cm ) with right side potentiometer4. Approve your selection by pressing briefly REMOTE / LOCAL button• Set second Calibration point (e.g. 18.0 m/min )• Repeat steps 1 - 4 with left side potentiometer• Message "Suc cES" in the display inform that calibration has ended successfully• After Calibration panel returns to the operation mode29