Kemppi MasterTig LT 250 Operating Manual

Also see for MasterTig LT 250: Quick guide

Contents

EN3.4 Operating functionsW0068591.2.3.4.5. 6. 7.8.9.10.1. Machine ’ON’ green light2. Pre/Post gas, upslope/downslope and main current parameter indicator.3. Welding parameter selector arrow keys.4. Welding process selection button (MMA or TIG).5. 2T or 4T TIG torch switch selection button. Select 2T for short welds or 4T for long welds.6. Ignition method selection button.7. Current adjustment selector: panel control, TIG Torch remote or foot pedal or hand remote.8. Welding current and parameter value control knob.9. Welding current and parameter value display: time and amperes.10. Overheating indicator.Switching the machine onWhen you power on the machine, the green standby indicator and panel are lit. Make sure thatthere is enough space around the machine to allow the air to freely circulate and flow into and outoff the machine. If the supply cables at the back of the LT 250 are connected in reverse order themachine will not work and the panel will not illuminate.3.4.1 Welding current regulation and remote controlThe welding current can be adjusted steplessly with the control knob, if panel adjustment (PANEL)is selected.If you want to adjust the welding current with the remote control, connect the remote control tothe machine and then select remote control with selector (7). The following remote control optionsare available: RTC10, RTC20, R10 and R11F. The remote foot pedal R11F can only be used with TIGwelding in 2T operation mode.3.4.2 MMA welding settingsMMA welding is selected when the indicator next to the MMA symbol is lit. If needed, press theprocess selection button to select the MMA process (4). The machine automatically sets suitablevalues to the ignition time, ignition pulse and arc dynamics.MasterTig LT 25010