Kemppi MinarcTig 180 Operating Manual

Also see for MinarcTig 180: Operating manual Operating instructions Operating manual

Contents

EN14setting parametersSelect the welding parameters with the arrow keys (3) and adjust theparameter values with the control knob (8). When setting the parameters,the display (2) will show the parameter being adjusted as well as thenumeric value that will be set for it. After three seconds, the display returnsto normal state and shows the welding current value.2.6.4 additional features for mlp models5.8.minilogWith the Minilog feature, you can switch between two current levels bypressing the switch briefly. The levels are the welding current and theMinilog current.To use the Minilog feature, press the button (5) so that the MINILOGindicator is lit. Use the arrow buttons to move the selector to Minilog currentand then set the desired Minilog current level with the control knob (8).The shielding gas starts to flow when the torch switch is pressed. When yourelease the switch, the current starts to rise (if an upslope time is established)to the set welding current level.Press the torch swich shortly (<1 sec) you can then easily switch up anddown between the two levels: welding current and Minilog current.When you press the switch for 1 second and then release it, the currentstarts to decrease. After a predetermined downslope time, the arc isdisconnected.14 MinarcTig 180, 180MLP, 250, 250 MLP